Woodstock W1761 User Manual download pdf (Page 62)

-48-

W1761/W1762 12" Table Saw with Riving Knife

SERVICE

10. Lower the arbor down all the way, remove the but-

ton head cap screws on the lower part of the belt

cover plate, the spacers, and the cover plate.

11. Roll the belt off of the upper and lower pulleys. Be

careful not to pinch your fingers.

To install the new belt, do these steps:

1. Place the new flat belt onto the lower pulley so it

engages one or two grooves.

2. Push the belt inward and roll it onto the top pul-

ley. Continue pushing the belt and rotating it up and

down (

FIgure 62) until it is centered on both pul-

leys.

3. Reinstall two button head cap screws and spacers

onto the lower part of the belt cover plate.

4. Raise the blade all the way up.

5. Perform Steps 6-9 in the previous subsection in

reverse order.

6. Loosen the motor mounting hex nuts, place the

wood block on top of the motor.

7. Raise the arbor assembly to tension the belt, ensur-

ing that the wood block is between the motor and

cabinet as shown in

Figure 63.

8. Check belt deflection as shown in Figure 64.

Note: The belt is tensioned correctly when you can

deflect it no more than

⁄8".

9. Tighten the motor mounting hex nuts, lower the

motor, and remove the wood block.

10. Close the motor cover.

Figure 62. Installing flat belt (table

removed for clarity.)

Figure 63. Using wood block to tension

belt.







Figure 64. Checking belt deflection.

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 87 88

No comments

Woodstock W1761 User Manual Page 62