Woodstock W1761 User Manual download pdf (Page 33)

-19-

W1761/W1762 12" Table Saw with Riving Knife

SET UP

5. While an assistant holds the extension table, fasten

the 93" front rail to the extension table with three

M8-1.25 x 25 flat head screws, flat washers and hex

nuts (

Figure 16). Finger tighten for now.

6. Fasten the 79" rear rail to the extension table with

three M8-1.25 x 25 cap screws, lock washers, flat

washers, and hex nuts, as shown in

Figure 17.

Finger tighten for now.

7. Align the table and extension table with a straight-

edge (

Figure 18), then tighten the fasteners in

Figure 16 with a 5mm hex wrench and 13mm

wrench.

8. Repeat the leveling procedure and tighten the fas-

teners in

Figure 17 with a 6mm hex wrench and

13mm wrench.

9. Using a 17mm wrench, tighten the hex bolts shown

in Figure 15.

10. Thread a

/8-16 hex nut on each foot and thread the

feet into the bottom of the support legs as shown in

Figure 19.

Figure 16. Front rail/table fastener

locations.

Figure 17. Rear rail/table fastener

locations.

Figure 19. Foot installed on support leg.

Foot

Support Leg

Hex Nut

Figure 18. Leveling main extension table.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 87 88

No comments

Woodstock W1761 User Manual Page 33