Woodstock W1761 User Manual download pdf (Page 32)

-18-

W1761/W1762 12" Table Saw with Riving Knife

SET UP

To install the front and rear rails, do these steps:

1. Fasten the 93" front rail onto the table saw with five

M8-1.25 x 25 flat head screws as shown in

Figure

13. Secure the flat head screw on the far left with a

flat washer, lock washer, and hex nut.

2. Fasten the 79" rear rail to the table with five M8-

1.25 x 25 cap screws as shown in

Figure 14. Secure

the cap screw on the far right with a flat washer,

lock nut, and hex nut.

3. Thread two M10-1.5 x 25 hex bolts with flat wash-

ers onto the right side of the table saw cabinet as

shown in

Figure 15. Do not fully tighten the bolts.

4. With the help of an assistant, place the extension

table between the rails and slide the table slots

over the bolts installed in Step 3

Extension Table

Figure 14. Rear rail installed.

Figure 15. Hex bolts installed.

Hex Bolts

Figure 13. Front rail installed.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 87 88

No comments

Woodstock W1761 User Manual Page 32