Woodstock W1761 User Manual download pdf (Page 39)

-25-

W1761/W1762 12" Table Saw with Riving Knife

SET UP

Dust Collection

Recommended CFM at Dust Port: 400 CFM

Do not confuse this CFM recommendation with the rat

ing of the dust collector. To determine the CFM at the

dust port, you must take into account many variables,

including the CFM rating of the dust collector, the length

of hose between the dust collector and the machine, the

amount of branches or wyes, and the amount of other

open lines throughout the system. Explaining this calcula-

tion is beyond the scope of this manual. If you are unsure

of your system, consult an expert or purchase a good dust

collection "how-to" book.

To connect a dust collection hose, do these steps:

1. Fit the 4" dust hose over the dust port, as shown in

Figure 36, and secure in place with a 4" hose clamp.

2. Tug the hose to make sure it does not come off.

Note: A tight fit is necessary for proper perfor-

mance.

Figure 36. Dust hose attached to dust

port.

Recommended

Adjustments

The adjustments listed below have been performed at the

factory and no further setup is required to operate the

machine.

However, because of the many variables involved with

shipping, we recommend checking the following adjust-

ments to ensure the best possible results from your new

machine:

Recommended adjustment checklist:

• Blade Tilt Stops on

Page 49

• Miter Slot to Blade Parallelism on

Page 51

DO NOT operate the Model W1761/W1762 without

an adequate dust collection system. This saw cre

ates substantial amounts of wood dust while oper

ating. Failure to use a dust collection system can

result in short and long-term respiratory illness.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 87 88

No comments

Woodstock W1761 User Manual Page 39