Woodstock W1761 User Manual download pdf (Page 37)

-23-

W1761/W1762 12" Table Saw with Riving Knife

SET UP

6. Slide the bracket screws shown in Figure 29 into the

notches on the splitter, push the guard toward the

back of the table, and tighten the lock knob (

Figure

30). If you have difficulty sliding the blade guard

bracket screws

(Figure 29) into the notches on the

splitter, loosen the bracket screws just enough so

the guard fits on the splitter.

Note: Make sure the clear plastic flap is pushed

toward the inside of the guard.

7. Swing the covers down to guard the blade.

Figure 29. Installing blade guard on

splitter.

Figure 30. Blade guard installed.

Notches

Bracket

Screws

Cover

Flap

Lock Knob

Riving Knife

Review this section, even if your saw riving knife came

pre-installed. You must install the riving knife or the split

ter and blade guard before operating the table saw.

To install the riving knife, do these steps:

1. Remove the table insert, blade guard, and split-

ter—if previously installed.

2. Loosen the hex bolt (Figure 31), insert the riving

knife into the bracket slot, and tighten the hex bolt

to secure the riving knife.

3. Reinstall and secure the table insert.

Figure 31. Riving knife installed.

Bracket

Riving Knife

Hex Bolt

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 87 88

No comments

Woodstock W1761 User Manual Page 37