Woodstock W1761 User Manual download pdf (Page 26)

-12-

W1761/W1762 12" Table Saw with Riving Knife

ELECTRICAL

DO NOT work on your electrical system

if you are unsure about electrical

codes and wiring! Seek assistance from

a qualified electrician. Ignoring this

warning can cause electrocution, fire,

or machine damage.

W1761 220V Single-Phase

Operation

The Model W1761 is wired for 220V single-phase opera-

tion. We recommend connecting this machine to a dedi

cated circuit with a verified ground, using the circuit

size given below. Never replace a circuit breaker with

one of higher amperage without consulting a qualified

electrician to ensure compliance with wiring codes. This

machine must be connected to a grounded circuit!

A plug is not supplied with this machine. See below for

the recommended plug type for this machine.

If you are unsure about the wiring codes in your area

or you plan to connect your machine to a shared cir

cuit, you may create a fire or circuit overload hazard—

consult a qualified electrician to reduce this risk.

We do not recommend using an extension cord; however,

if you have no alternative, use the following guidelines:

• Use a cord rated for Standard Service (S).

• Do not use an extension cord longer than 50 feet.

• Ensure that the cord has a ground wire and pin.

• Use the gauge size listed below as a minimum.

Extension Cords

Operating Voltage Amp Draw Min. Circuit Size Recommended Plug Extension Cord

220V Operation 23 Amps 30A NEMA L6-30 (not

incl.) (See Figure 7)

10 Gauge, 3 Wire,

250V

Figure 7. L6-30 plug and receptacle.

L6-30 P

L6-30 R

W1761 Electrical

Specifications

The machine must be properly set up before it is

safe to operate. DO NOT connect this machine to the

power source until instructed to do so in the "Test

Run" portion of this manual.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 87 88

Comments to this Manuals

No comments

Woodstock W1761 User Manual Page 26

Comments to this Manuals