-20-
=`^li\)0%Pulley speed chart.
=`^li\*'%Loosening spindle slide bolts.
8;ALJKD<EKJ
Jg`e[c\IGD
This shaper spindle can be run at 7,000 or 10,000
RPM. The speed is changed by the placement of
the V-belt as shown in =`^li\)0%
KfZ_Xe^\k_\jg`e[c\IGD#[fk_\j\jk\gj1
(%LEGCL>K?<J?8G<I
)% Loosen the two spindle slide bolts that hold
the motor mount plate to the spindle slide
as shown in =`^li\*'% DO NOT remove the
bolts completely.
*% Position the V-belt on the pulleys according
to the desired spindle speed.
+% Slide the motor and motor mount plate
assembly until the V-belt is snug and tighten
the bolts. The amount of V-belt deflection
should be
1
⁄4" when pressed with your
thumb.
,% Tighten all fasteners securely.
-% Make sure the V-belt is correctly aligned on
both pulleys.
:_ffj\Jg`e[c\IGD1
Always follow cutter manufacturer
recommendations; however, if not available
use these general specifications to help select
spindle and RPM. NOTE: Always use the
largest spindle possible, and only use a one
bushing at a time when reducing the cutter
inside diameter.
For shaper cutters smaller than 3
1
⁄2"
in diameter run the spindle at 10,000
RPM.
For shaper cutters 3
1
⁄2" and larger in
diameter, run the spindle at 7,000 RPM.
Comments to this Manuals