Woodstock THE SHOP FOX W1500 Specifications download pdf (Page 34)

-19-

Glcc\p8c`^ed\ek

Pulley alignment is important to the performance

of your shaper. If the pulleys are just slightly

out of alignment, the shaper may suffer from

power loss as well as decreased V-belt life. The

pulleys need to be parallel with one another for

optimum shaper performance.

KfXc`^ek_\glcc\pj#[fk_\j\jk\gj1

(%LEGCL>K?<J?8G<I

)% Remove the motor cover from the side of the

shaper.

*% Hold a straightedge up to the pulleys to

determine if they are aligned correctly as

shown in =`^li\)-%

+% If the motor pulley is not aligned with the

spindle pulley, loosen the four motor mount

bolts as shown in =`^li\)..

,% Wiggle the motor until the pulley is aligned

with the spindle pulley.

-% If the spindle pulley is not aligned with the

motor pulley, loosen the bolt on the spindle

slide that holds the spindle in place as shown

in =`^li\)/%

.% Place a pad on the floor underneath the

spindle to prevent damage if it falls to the

floor.

/% Slowly wiggle the spindle up or down into

alignment with the motor pulley. Wiggle the

spindle slowly so the spindle does not slide

too fast or drop to the floor.

0% After you adjust the pulleys, check the

alignment with the straightedge again. Once

you are satisfied with the results, tighten

down all the fasteners, and recheck one more

time after all the fasteners are secure.

=`^li\)-%Use straightedge to check V-belts.

=`^li\).%Loosening motor mount bolts.

=`^li\)/%Loosening spindle cartridge bolt.

8;ALJKD<EKJ

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 68 69

Comments to this Manuals

No comments