Woodstock THE SHOP FOX W1500 Specifications download pdf (Page 28)

-13-

?Xe[n_\\c

The handwheel comes installed from the

factory; however, you will need to install the

crank handle. NOTE: for each revolution of

the handwheel, the spindle moves up or down

approximately 0.045".

Kf`ejkXcck_\ZiXeb_Xe[c\#[fk_\j\jk\gj1

(% Thread the crank handle into the hole on the

face of the handwheel as shown in =`^li\

(..

)% Using a 14mm open-end wrench, tighten the

crank handle securely, making sure the hand

wheel rotates freely.

=`^li\(.%Attaching the crank handle.

?fc[$;fnej

The hold-downs hold the workpiece against the

fence and the table. NOTE: Remove the hold-

down assembly when not in use.

Kf`ejkXcck_\_fc[$[fnej#[fk_\j\jk\gj1

(% Install two aluminum hold-down brackets

onto each of the hold-down bars as shown in

=`^li\(,.

)% Insert the long end of the hold-down bar

through the hole in the fence mount as

shown in =`^li\(,.

*% Adjust the hold-down fence mount to the

desired position along the top edge of the

fence casting.

+% Screw in, but do not tighten, the

1

⁄4"-20 x

3

⁄8" setscrews into the aluminum hold-down

brackets as shown in =`^li\(,.

,% Slide each hold-down into the slot between

the aluminum hold-down bracket and hold-

down bar.

-% Position each of the hold-downs into place for

your workpiece as shown in =`^li\ (-, and

tighten the setscrews in the fence mounts and

the aluminum hold-down brackets.

=`^li\(,%Assembling hold-down mechanism.

=`^li\(-%Assembled hold-down mechanism.

?fc[$[fne

9iXZb\k

8JJ<D9CP

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 68 69

Comments to this Manuals

No comments