Woodstock W1708 Specifications download pdf (Page 26)

-24-

W1708 Owner's Manual (Mfg. 10/07+)

SERVICE

Table/Disc Parallelism

The edge of the table must be parallel with the face

of the sanding disc, and there should be a

⁄16'' gap

between the two. This gap should be large enough so that

the sandpaper does not rub against the table, but small

enough so that the gap is not a pinch hazard.

To make the table and sanding disc parallel, do these

steps:

1. DISCONNECT MACHINE FROM POWER!

2. Using a 10mm wrench and Phillips head screwdriver

loosen the six flat head screws and hex nuts that

secure the table to the table support brackets.

3. Adjust the table so that there is a

⁄16'' gap (Figure

15) between the 12" disc (with sandpaper installed)

and the table, from left to right.

4. When the table is parallel with the sanding disc,

tighten the flat head screws and hex nuts.

5. Spin the disc by hand to check if the sandpaper is

touching the table.

Note: DO NOT turn the disc sander on at this point.

6. Re-adjust the table parallelism if the sandpaper

touches the table at any point in its rotation.

Figure 15. Table parallel with sanding

disc.

⁄16"

Gap

Flat

Head

Screws

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 35 36

No comments

Woodstock W1708 Specifications Page 26