Woodstock W1708 Specifications download pdf (Page 16)

-14-

W1708 Owner's Manual (Mfg. 10/07+)

OPERATIONS

Basic Controls

Refer to Figure 8 and the following descriptions to

become familiar with the basic controls of this machine.

Paddle Switch: Turns the motor ON when flipped up;

turns motor OFF when pressed down.

Switch Disabling Key: Disables the switch when the

yellow key is removed.

Table Tilt Lock Handles: Locks the table in place. To tilt

the table, loosen the handles (Figure 8), tilt the work

table to the desired angle, then retighten the handles.

The work table should be set approximately

⁄16" away

from the sanding disc to prevent fingers or workpieces

from getting caught. To adjust the work table relative to

the sanding disc, refer to in Table/Disc Parallelism on

Page 24.

Miter Gauge: Moves workpieces into the sanding disc

at a specific angle. To use the miter gauge, slide it into

the miter slot, loosen the lock knob, set the angle, then

tighten the knob.

Figure 8. Basic controls.

Miter Gauge

Operation Overview

This overview gives you the basic process that happens

during an operation with this machine. Familiarize your-

self with this process to better understand the Operations

section.

To complete a sanding operation, the operator does the

following:

1. Examines the workpiece to make sure it is suitable

for sanding.

2. Adjusts the table tilt, if necessary, to the required

sanding angle, and locks the table in place.

3. Inserts the miter bar in the miter slot.

4. Adjusts the miter angle for the required sanding

angle, and locks it in place.

5. Uses the appropriate clamping device or jig for small

workpieces.

Table Tilt Lock Handles

Paddle

Switch

Switch Disabling Key

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 35 36

Comments to this Manuals

No comments

Woodstock W1708 Specifications Page 16

Comments to this Manuals

Related products and manuals for Garden shredders Woodstock W1708