Woodstock W1708 Specifications download pdf (Page 24)

-22-

W1708 Owner's Manual (Mfg. 10/07+)

SERVICE

This section covers the most common problems and corrections with this type of machine. WARNING!

DO NOT make any adjustments until power is disconnected and moving parts have come to a com-

plete stop!

If you require additional machine service not included in this section, please contact Woodstock

International Technical Support at (360) 734-3482 or send e-mail to: tech-support@shopfox.biz.

Troubleshooting

PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION

Machine does not start.

1. Switch disabling key removed.

2. Break or short in wiring, loose

connections,plug or receptacle is

corroded or miswired.

3. Power supply switched off/has

incorrect voltage.

4. Blown fuse/tripped circuit breaker

at main panel.

5. Motor connection wired incorrectly.

6. Motor ON/OFF switch at fault.

7. Start capacitor has blown.

8. Centrifugal switch at fault.

9. Motor at fault.

1. Reinstall switch disabling key.

2. Trace/replace broken or corroded wires, fix loose

connections, correct wiring.

3. Switch power supply on/verify voltage.

4. Correct the cause of overload, then reset/replace

fuse or breaker.

5. Wire motor correctly (refer to inside junction box-

cover).

6. Replace switch.

7. Test/replace if at fault.

8. Adjust/replace centrifugal switch.

9. Test for shorted windings or bad bearings; repair or

replace.

Machine has excessive

vibration or noise.

1. Workpiece loose or incorrectly

secured.

2. Motor fan rubbing on fan cover.

3. Motor mounting loose.

4. Lock handle is loose.

5. Machine incorrectly mounted to

bench.

6. Centrifugal switch out of adjust-

ment; at fault.

7. Motor bearings worn or damaged.

1. Use correct holding fixture and re-clamp

workpiece.

2. Fix/replace fan cover; replace loose or damaged

fan.

3. Tighten mounting bolts/nuts; use thread locking

fluid.

4. Tighten the lock handle.

5. Level/shim base; tighten/adjust mounting hard-

ware or feet.

6. Adjust/replace centrifugal switch.

7. Replace motor bearings or replace motor.

Motor & Electrical

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 35 36

Comments to this Manuals

No comments

Woodstock W1708 Specifications Page 24

Comments to this Manuals

Related products and manuals for Garden shredders Woodstock W1708