Woodstock SHOP FOX M1106 Specifications download pdf (Page 39)

-37-

D('0/(*o+'>\Xi?\X[CXk_\

FG<I8K@FEJ

=`^li\,/% Gear cover.

:_Xe^\>\Xij

=`^li\,0% Change gear locations.

>\XiiXk`f`jXj]fccfnj1

+'KÇ5()'K

().KÇ5+'K

The Model M1098 lathe comes with 40, 127, 120, and 30

tooth gears installed. One extra 40 tooth gear is included

so gear ratios can be altered for threading operations.

The charts on the machine indicate which ratios are

applicable for an intended operation.

KfZ_Xe^\k_\^\Xij#[fk_\j\jk\gj1

(% DISCONNECT POWER TO THE LATHE!

)% Remove two thumb knobs and remove the headstock

gear cover to expose the change gears (=`^li\,/).

*% Loosen the gear adjuster (=`^li\,0),and let the

gear swing down.

+% Remove the appropriate change gear according to

your the chart, and install the required gear (see

=`^li\,0).

,% Mesh the gear teeth, and tighten the gear adjuster

back in place so there is a slight amount of gear-

tooth backlash, approximately from 0.002" to 0.005".

 Efk\1J\kk`e^k_\^\Xijkffk`^_kn`ccZXlj\\oZ\j$

j`m\n\XiXe[ef`j\%J\kk`e^k_\^\Xijkffcffj\dXp

ZXlj\jc`ggX^\Xe[gfjj`YcpYi\Xb^\Xik\\k_%

-% Oil the gears, reinstall the gear cover, and recon-

nect power to the machine.

Thumb

Knob

Gear

Adjuster

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 83 84

No comments

Woodstock SHOP FOX M1106 Specifications Page 39