Woodstock SHOP FOX M1106 Specifications Page 19

  • Download
  • Add to my manuals
  • Print
  • Page
    / 84
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 18
-17-
D('0/(*o+'>\Xi?\X[CXk_\
FG<I8K@FEJ
K_i\\$AXn;`i\ZkDflek
JZifcc:_lZb
Three-jaw scroll chucks feature hardened steel jaws that
self-center the workpiece within 0.002"-0.003". An extra
set of jaws is included for machining larger workpieces.
The three-jaw direct mount scroll chuck featured in these
instructions has three cam-lock studs that mount directly
to the chuck and hold the chuck tight to the spindle
nose.
Kfi\dfm\fidflekpflik_i\\$aXn[`i\ZkdflekjZifcc
Z_lZbpfln`cce\\[k_\]fccfn`e^kffcj1
• Chuck Key
• Dead Blow Hammer
A Chuck Cradle or a piece of plywood large enough
to span the bedways and support the weight of the
chuck
• Breaker Bar (optional)
Kfi\dfm\k_\\o`jk`e^Z_lZb#[fk_\j\jk\gj1
(% DISCONNECT POWER TO THE LATHE!
)% Lay a chuck cradle or protective layer of plywood
over the bedways to protect the precision ground
surfaces from damage and to prevent fingers from
being pinched (see =`^li\(-).
*. Loosen the 3 cam-locks by turning the chuck key
counterclockwise until the mark on the cam-lock
aligns with the single mark on the spindle nose in
=`^li\(.% This will be approximately one-third of a
turn. If you look carefully, you will see the cam-lock
rise up out of the spindle nose. If the cam-lock stud
does not freely release from the cam-lock, wiggle
the cam-lock until the cam-lock stud releases.
Efk\1 K_\j\ZXd$cfZbjdXpY\m\ipk`^_k%8Yi\Xb\i
YXidXpY\lj\[kfX[[c\m\iX^\%
G@E:? ?8Q8I; Gifk\Zk pfli _Xe[j
Xe[ gi\Z`j`fe ^ifle[ Y\[nXpj
n`k_ gcpnff[ n_\e i\dfm`e^ cXk_\
Z_lZb K_\ _\Xmp n\`^_k f] X ]Xcc$
`e^ Z_lZb ZXe ZXlj\ j\i`flj `ealip%
=`^li\(-%Simple chuck cradle made of
scrap lumber.
=`^li\(.%Loosening the cam-locks.
Page view 18
1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 83 84

Comments to this Manuals

No comments