Woodstock SHOP FOX D3736 Instruction Manual download pdf (Page 9)

Model D3736 Palm Finishing Sander

-7-

Determine the appropriate grit size for

your project and sand the work evenly

in the same direction as the grain of the

wood. Always keep the sander moving so

the finish of your work stays consistent.

If the sander stays in one place too long,

then it may produce a depression in the

wood that will compromise your finish.

Sanding across the grain of the wood may

be necessary in some cases to remove

rough defects. This should be done with

caution, however, because it can produce

cross-grain scratching that will require

further sanding to remove.

Tip: Try using the sandpaper that

came with your sander as a template

for cutting holes in new

1

⁄4 sheets

to match those on the bottom of the

sander—so the dust bag can collect

dust particles. Use a paper punch

to cut the holes; or mark the holes,

score them with a sharp knife, and

cut them out.

Electrical shock hazard! Only use

sander for dry sanding. Never use

sander for wet sanding!

Change sheets as soon as the grit

becomes dull. And, never apply excessive

force while sanding. Your sander and

paper will last longer if you let them do

the work.

Using the dust bag will help keep your

work area clean and reduce dust particle

emission.

To install the dust bag, do these steps:

1. Insert the dust bag spout into the

dust port and make sure it fits snugly.

2. When the dust bag is half full,

remove the dust bag from the sander

and empty it into a trash receptacle

by gently tapping on the side of the

bag.

Always wear a respirator or dust mask

and safety glasses when emptying the

dust bag.

Attaching Dust Bag

Using the Sander

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments