Woodstock SHOP FOX W1755 Owner's Manual download pdf (Page 41)

-39-

W1755 6" Parallelogram Jointer

SERVICE

Pulley Alignment

Pulley alignment is another important factor in power

transmission and belt life. The pulleys should be parallel

to each other and in the same plane (coplanar) for opti

mum performance.

Each pulley can be adjusted by loosening the motor

mount bolts, sliding the motor in or out, and retightening

the fasteners to lock the motor pulley in place.

To align the pulleys, do these steps:

1. DISCONNECT JOINTER FROM POWER SOURCE!

2. Open the back cover and remove the belt guard.

3. Visually check the alignment of the two pulleys to

make sure that they are aligned and that the V-belts

are straight up and down (see

Figure 67).

— If the pulleys are aligned, go to Step 8

— If the pulleys are NOT aligned, do Steps 4–7

4. Loosen the motor mount bolts shown in Figure 68.

5. Shift the motor horizontally as needed to align the

motor pulley with the cutterhead pulley.

6. Tighten the motor mount bolts.

7. Close the back cover and reinstall the belt guard.

Figure 67. Pulleys aligned.











Figure 68. Motor mount bolts for adjusting

pulley alignment.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 55 56

No comments

Woodstock SHOP FOX W1755 Owner's Manual Page 41