Woodstock SHOP FOX W1755 Owner's Manual download pdf (Page 38)

-36-

W1755 6" Parallelogram Jointer

SERVICE

Setting Infeed Table

Height

The infeed table on the Model W1755 has positive stop

bolts that, when properly set up, allow the operator to

quickly adjust the infeed table between finish/final cuts

(top height) and shaping/heavy cuts (bottom height).

We recommend setting the minimum depth of cut to

/32"

and the maximum depth of cut to

/8" for most opera-

tions. DO NOT exceed

⁄8" cut per pass on this machine

or the risk of kickback and serious injury will greatly

increase!

Each positive stop bolt (Figure

57) controls the top or

bottom range of the table movement. The jam nut locks

the positive stop bolt in position so it will not move dur

ing operation.

Figure 57. Positive stop bolts for infeed

table.

Top Height

Bottom Height

Calibrating Depth Scale

The depth scale on the infeed table can be calibrated or

“zeroed” if it is not correct.

To calibrate the depth scale, do these steps:

1. DISCONNECT JOINTER FROM POWER SOURCE!

2. Loosen the infeed table positive stop bolts.

3. Use the straightedge to help adjust the infeed table

exactly even with the outfeed table, as shown in

Figure 58.

4. Using a screwdriver, adjust the scale pointer to “0”

(Figure 59), then reset the infeed table positive

stops.

Figure 59. Depth scale adjusted to “0”

position.

Jam Nuts





Figure 58. Infeed table even with outfeed

table.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 55 56

Comments to this Manuals

No comments

Woodstock SHOP FOX W1755 Owner's Manual Page 38

Comments to this Manuals

Related products and manuals for Power planers Woodstock SHOP FOX W1755