Woodstock W1829 User Manual download pdf (Page 35)

-33-

Model W1829 (Mfg. Since 9/11)



     

    

      



 

Flathead Screwdriver ..........................................1

Wrench 8mm .....................................................1

Wrench 10mm ...................................................1



 DISCONNECT THE JOINTER FROM POWER!

 Position the fence over the bed and tighten the

sliding handle, loosen the fence tilting handle.

 Press the forward tab of the limit plate into the rear

slot of the limit block.

 Tilt the fence as far as it will go towards 90º

(perpendicular to the table) until it hits the limit

block shaft. Tighten the fence tilting handle.

 Use a square to check the angle of the fence, as

shown in .

— If the fence is perpendicular to the table, the

90º stop is set correctly; no additional steps are

necessary. Proceed to set the 45º inward and 45º

outward stops (see Page 34).

— If the fence is not perpendicular to the table,

adjust the 90º stop by doing .

 Loosen the fence tilting handle, bring the fence

to 90º with the square set against the fence, then

tighten the handle.

 Note:Keep the limit plate tab in the rear slot of

the limit block.

 Loosen the jam nut (located at the rear of the limit

block shaft).

 Using a flathead screwdriver, turn the limit block

shaft until it hits the fence.

 Tighten the jam nut. The 90º stop is now set.



 Checking the 90º stop.

 Fence stop parts identification.

Limit Plate

Tab

Inward Stop

Limit Block

Rear Slot

Jam

Nut

Limit Block

Shaft

This section provides instructions for setting the fence

angle stops precisely at 90°, 45° inward, or 45° outward.

Note:To ensure accurate results when edge jointing,

check the accuracy of these settings frequently (monthly

at a minimum) and re-adjust them if necessary.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 47 48

Comments to this Manuals

No comments

Woodstock W1829 User Manual Page 35

Comments to this Manuals