Woodstock W1672 Instruction Manual download pdf (Page 14)

13

Figure 14. Installing pulley on motor.

Figure 15. Installing motor.

Mounting Motor

1. Make sure the key is in place in the keyway

on the motor shaft. Align the keyway and

slide the motor pulley onto the motor shaft

as far as it will go. Figure 14.

2. Align pulley with the hole in the back of the

bandsaw body. Slide the motor until mounting

holes align with those in top of the stand.

Figure 15.

3. Secure the motor with the (4)

5

⁄16"-18 x 1" car-

riage bolts,

5

⁄16" hex nuts, lock washers and

flat washers provided.

4.

Line the motor pulley up with the lower

wheel pulley and tighten the setscrew with

the Allen

®

wrench provided.

To eliminate troublesome wiring, the motor for

your bandsaw has a quick-connect cord that

leads from the motor to the switch. The recep-

tacle end of this cord comes out of the bandsaw

body near the motor and the plug end of the

cord is already attached to the motor.

1. Locate the two plug ends and connect them

together as shown in Figure 16.

2. Do Not become confused with the switch-

to-power cord. It will not fit in the quick-

connect receptacle. Do Not plug the switch-

to-power cord into the power source at this

time.

Quick-Connect Cord

Figure 16.

Plugging motor to switch.

Do not rely on quick con-

nect cord when making

adjustments to bandsaw.

Always unplug directly at

the power source.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 44 45

Comments to this Manuals

No comments