Woodstock W1713 Instruction Manual download pdf (Page 21)

To replace the motor brushes, do these steps:

1. Using a flat-head screwdriver, remove the

motor brush caps. The top cap is accessible

from the top of the scroll saw and the bot-

tom cap is accessible through a hole on the

bottom of the base (Figure 13).

2. Replace the motor brushes if they are dam-

aged or severely blackened by carbon build-

up.

3. Re-install the motor brush caps.

Figure 13. Motor brush cap (1 of 2).

MAINTENANCE

-19-

Make sure that your

machine is unplugged

during any maintenance

procedures except

where instructed other-

wise! If this warning is

ignored, serious person-

al injury may occur.

Regular periodic maintenance on your Model

W1713 will ensure its optimum performance.

Make a habit of inspecting your machine each

time you use it. Check for the following condi-

tions and repair or replace when necessary:

• Loose mounting bolts.

• Worn switch.

• Worn or damaged cords and plugs.

• Any other condition that could hamper the

safe operation of this machine.

The arm bearings (Figure 12) on each side of the

scroll saw need to be lubricated after every 6-10

hours of use. Unplug the saw, lay it on its side,

and apply a generous amount of SAE 20 oil. Let

stand overnight. Perform the same procedure to

the opposite side bearings.

Figure 12. Arm bearings.

Motor Brushes

Arm Bearings

General

MAINTENANCE

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 27 28

Comments to this Manuals

No comments