Woodstock W1713 Instruction Manual download pdf (Page 13)

ASSEMBLY

-11-

To prepare the table surface for workpieces,

do these steps:

Clean the table surface with a rust preventative

such as SLIPIT

®

.

UNPLUG POWER CORD

before you do any assem-

bly or adjustment tasks!

Otherwise, serious per-

sonal injury to you or oth-

ers may occur!

Read and understand this

entire instruction manual

before performing any

operations with your

machine. Serious personal

injury may occur if safety

and operational informa-

tion is not understood and

followed.

Figure 2. Blade guard mounting location.

The scroll saw can be mounted to a workbench

two ways:

• Permanent mounting can be accomplished

by bolting the base to the workbench.

Because workbench table thickness can

vary, fasteners have not been supplied.

• Temporary mounting can be accomplished

by securing the base of the scroll saw to a

piece of

3

⁄4" plywood that measures at least

21" x 14". The scroll saw/plywood assembly

can then be temporarily clamped to a work-

bench or other suitable working surface.

Vibration caused by operating the scroll saw can

be reduced by placing a foam pad or piece of

carpet between the saw base and the work-

bench.

The blade guard must be installed before turn-

ing the scroll saw ON and before performing a

cutting operation.

To install the blade guard, do these steps:

1. UNPLUG THE SCROLL SAW!

2. Using the supplied screw, nut, and washers,

install the clear blade guard onto the drop

foot rod (Figure 2). Over-tightening the

bolt could break the clear plastic arms of

the blade guard.

3. Swing the blade guard up and down to

ensure that it moves smoothly.

Blade Guard

Table Prep

Mounting Scroll Saw

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 27 28

Comments to this Manuals

No comments