Woodstock SHOP FOX M1113 Specifications download pdf (Page 45)

-43-

Model M1113 (Mfg. Since 2/08)



 Tighten the blade, then check the wheels. (Coplanar

wheels may pull out of alignment when the blade is

tightened.)

 When the wheels are coplanar, place a mark on each

wheel where you held the straightedge. This assures

repeated accuracy every time you adjust your

wheels.

 When wheels are properly coplanar, the blade

may not be centered on the crown of the wheel, but

it will be balanced.



Only do this procedure if you cannot make the wheels

coplanar with the tracking knob or by shimming the upper

wheel. Make sure the upper wheel is adjusted as close as

possible to being coplanar with the lower wheel before

beginning. Do this procedure with the blade fully ten-

sioned.



 DISCONNECT BANDSAW FROM POWER!

 Loosen the four hex bolts on the lower wheel adjust-

ment hub ().

 Rotate the wheel adjustment sleeves to tilt the

lower wheel as necessary to make it coplanar with

the upper wheel.

 Tighten the hex bolts to lock the wheel adjustment

sleeves in position.

 Wheel adjustment hub.

Wheel

Adjustment

Sleeve

Hex Bolt

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 59 60

No comments

Woodstock SHOP FOX M1113 Specifications Page 45