Woodstock SHOP FOX M1113 Specifications download pdf (Page 43)

-41-

Model M1113 (Mfg. Since 2/08)





 Cut a piece of scrap wood approximately

⁄4" thick

x 3" wide x 17" long. On a wide face of the board,

draw a straight line parallel to the long edge.

 Slide the fence out of the way and cut free-hand

along the line. Stop at the halfway point. Turn the

bandsaw OFF and wait for the blade to stop.

 Clamp the board to the bandsaw table without mov-

ing it. Now slide the fence over to the board so it

barely touches one end of the board.

 Loosen the two cap screws that mount the front rail

brackets to the table.

 Shim between the front rail brackets and the table

as necessary to make the fence parallel to the edge

of the scrap piece.





 Set the miter gauge to 90° and verify that the gauge

body is square to the miter bar, using a 90° square.

 On a scrap piece of wood, mark a line that is per-

pendicular to the front edge of the workpiece.

 Starting where the line begins, cut the board by

pushing it through the blade with the miter gauge.

 Loosen the table trunnion mounting bolts, and shift

the table to compensate for the blade lead.

 Repeat  until the blade cuts straight

when wood is pushed through with the miter gauge.

NOTICE

If the table is shifted, the fence will be

affected since it is attached.

NOTICE

Lead adjustments will change when new

blades are mounted on the saw.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 59 60

No comments

Woodstock SHOP FOX M1113 Specifications Page 43