Woodstock SHOP FOX M1106 Specifications download pdf (Page 35)

-33-

Model W1811 (For Machines Mfd. Since 6/14)

OPERATIONS

Operation Overview

The purpose of this overview is to provide

the novice machine operator with a basic

understanding of how the machine is used during

a typical operation, so the controls/components

discussed later in this manual are easier to

understand.

Due to the generic nature of this overview, it is

not intended to be an instructional guide. To learn

more about specific operations, read this entire

manual, read "how to" books, and seek additional

training from experienced machine operators.

To complete a typical operation, the operator

does the following:

1. Examines the workpiece to make sure it is

suitable for cutting.

2. Adjusts the blade tilt, if necessary, to the

correct angle for the desired cut.

3. Adjusts the blade height approximately

1

⁄4"

higher than the thickness of the workpiece.

4. Adjusts the fence to the desired width of cut,

then locks it in place.

5. Checks the outfeed side of the machine

for proper support and to make sure the

workpiece can safely pass all the way through

the blade without interference.

6. Puts on safety glasses and a respirator.

Locates push sticks/blocks if needed.

7. Starts the saw.

8. Feeds the workpiece all the way through the

blade while maintaining firm pressure on the

workpiece against the table and fence, and

keeping hands and fingers out of the blade

path and away from the blade.

9. Stops the machine immediately after the cut

is complete.

Workpiece Inspection

Some workpieces are not safe to cut on this

machine or may need to be modified before they

can be safely cut.

Before beginning the cutting operation, inspect

all workpieces for the following:

• Material Type. This machine is intended for

cutting natural and man-made wood prod-

ucts, laminate covered wood products, and

some plastics. Cutting drywall or cementi-

tious backer board creates extremely fine

dust and may reduce the life of the motor

bearings. This machine is NOT designed to cut

metal, glass, stone, tile, etc.; cutting these

materials with a table saw greatly increases

the risk of injury and damage to the saw or

blade.

• Foreign Objects. Nails, staples, dirt, rocks

and other foreign objects are often embed-

ded in wood. While cutting, these objects can

become dislodged and hit the operator, cause

kickback, or break the blade, which might

then fly apart. Always visually inspect your

workpiece for these items. If they can’t be

removed, DO NOT cut the workpiece.

• Large/Loose Knots. Loose knots can become

dislodged during the cutting operation. Large

knots can cause kickback and machine dam-

age. Choose workpieces that do not have

large/loose knots or plan ahead to avoid cut-

ting through them.

• Wet or “Green” Stock. Cutting wood with a

moisture content over 20% causes unneces-

sary wear on the blades, increases the risk of

kickback, and yields poor results.

• Excessive Warping. Workpieces with exces-

sive cupping, bowing, or twisting are danger-

ous to cut because they are unstable and may

move unpredictably when being cut.

• Minor Warping. Slightly cupped workpieces

can be safely supported with the cupped

side facing the table or fence; however,

workpieces supported on the bowed side will

rock during the cut, which could cause kick-

back.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 99 100

Comments to this Manuals

No comments