Woodstock SHOP FOX W1730 User Manual download pdf (Page 22)

-20-



W1730 Oscillating Edge Sander



 Use a machinist's square with one edge against the

face of the miter gauge and the other against the

belt face as shown in .

 Lock the lock knob on the miter gauge and adjust

the miter gauge flush with the edge of the square.

 Tighten the lock knob, and verify the setting. :

Sometimes the tightening procedure can affect the

adjustment.

 Loosen the screw that secures the angle pointer and

adjust the pointer to the 0˚ mark on the scale.

 Retighten the screw that secures the angle pointer.



Squaring the miter gauge.

The Model W1730 comes with a removable fence to assist

sanding operations when the platen is horizontal.



 Set the fence on the table and align the slots with

the threaded holes in the table.

 Thread the star knobs and 5/16" flat washers into

the threaded table holes () and tighten.



Installed fence.

The spindle table on the oscillating edge sander can

be moved vertically to accommodate various sanding

operations and to decrease spot wear on the sanding

drums.





 Loosen the adjustment lock handle shown in 

.

 Raise or lower the table to the desired height.

 Tighten the adjustment lock handle.



Adjustment lock handle.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 39 40

No comments

Woodstock SHOP FOX W1730 User Manual Page 22