Woodstock SHOP FOX M1106 User Manual download pdf (Page 21)

-19-

D((()()o*->lejd`k_`e^CXk_\D]^%J`eZ\+&'/

J<KLG

KX`cjkfZb

=`^li\16%Finished dead center.

=`^li\(.% Bar stock mounted on centers.

=`^li\(/% Adjusting for headstock end

taper.

Add`^c\Ydlc[gdbVWdkZ#

BdkZiV^ahidX`idlVgY

back d[aVi]Z]Va[i]Z

Vbdjcid[iVeZg

The tailstock alignment was set at the factory with the

headstock. However, we recommend that you take the

time to ensure that the tailstock is aligned to your own

desired tolerances.

KfXc`^ek_\kX`cjkfZb#[fk_\j\jk\gj1

(% Center drill a 6'' long piece of bar stock on both

ends. Set it aside for use in Jk\g+.

)% Make a dead center by turning a shoulder to make

a shank. Flip the piece over in the chuck and turn a

60° point (s\\=`^li\16)%As long as it remains in

the chuck, the point of your center will be accurate

to the spindle axis.

Efk\1B\\g`ed`e[k_Xkk_\gf`ekn`cc_Xm\kfY\

i\]`e`j_\[n_\e\m\i`k`ji\dfm\[Xe[i\klie\[kf

k_\Z_lZb%

*% Place the live center in your tailstock.

+% Attach a lathe dog to the bar stock from Jk\g( and

mount it between the centers(as shown in =`^li\

17).

,% Turn approximately 0.010" off the diameter.

-% Mount a dial indicator so that the plunger is on the

tailstock barrel (=`^li\18).

.% Measure the stock with a micrometer. If the stock is

wider at the tailstock end, the tailstock needs to be

moved toward the cutter the amount of the taper

(=`^li\18).

— If the stock is thinner at the tailstock end, the

tailstock needs to be moved away from the

operator by half the amount of the taper (=`^li\

19).

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 83 84

No comments

Woodstock SHOP FOX M1106 User Manual Page 21