Woodstock SHOP FOX W1774 Owner's Manual download pdf (Page 10)

Model W1774 18 Gauge Brad Nailer

-8-

OPERATIONS

Loading

When replacing nails in your Model

W1774, follow these guidelines:

Gauge: ........................................18

Length: ..................................

5

⁄8"–2"

Capacity: ................................... 100

To load your nailer, do these steps:

1. DISCONNECT NAILER FROM THE AIR

SUPPLY!

2. Depress the magazine latch, as shown

in Figure 2.

3. Pull the magazine cover back until it

stops.

4. Insert a strip of nails, pointed-end

down, into the magazine, as shown in

Figure 3.

If you have not read the safety

instructions in this manual, do not

operate the nailer.

Before you operate your nailer, place five

to six drops of quality pneumatic tool oil

into the quick connect fitting where the

nailer connects to the air supply.

To operate your nailer, do these steps:

1. Connect the air supply to the quick

connect fitting.

2. To test for proper nail penetration,

hold the nailer perpendicular to the

surface of a piece of clean scrap

wood that is thick enough for the

length of nails you have loaded.

Operating

5. Slide the nails all the way down to

the nose of the nailer.

6. Push the magazine cover forward

until the magazine latch locks it in

place.

Figure 3. Loading nails into magazine.

Figure 2. Releasing magazine latch.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Comments to this Manuals

No comments