INSTRUCTION MANUALMODEL M1024 TAPER ATTACHMENT FOR USE WITH MODEL M1020Phone: 1-360-734-3482 • On-Line Technical Support: [email protected]
-10-M1024 Taper AttachmentPARTS
-11-M1024 Taper AttachmentParts ListREF PART # DESCRIPTION REF PART # DESCRIPTION1 XM1024001 CLAMPING JAW 21 XM1024021 SUPPORT SPACER2 XM1024002 CLAMP
-2-M1024 Taper Attachment
-3-M1024 Taper AttachmentNOTICEWhen ordering replacement parts, refer to the parts list and diagram in the back of the manual.The following is a descr
-4-M1024 Taper AttachmentINSTALLATIONFigure 2. Back of lathe with splash guard removed.Installing the Taper AttachmentTo install the taper attachment,
-5-M1024 Taper Attachment5. Remove the two cap screws securing the bearing housing. Leave the remaining thrust bearing on the lead screw (Figure 4).
-6-M1024 Taper AttachmentFigure 7. Mounting main body onto lathe while tightening cap screws.Figure 8. Tightening cap screws under main body.Figure 9.
-7-M1024 Taper AttachmentFigure 10. Deadman components.Figure 11. Installing support rod onto taper attachment. Figure 12. Deadman installed onto tape
-8-M1024 Taper AttachmentOPERATIONS Angle AdjustmentsThe taper angle is adjusted by loosening the two cap screws at the ends of the taper bar on the t
-9-M1024 Taper AttachmentFigure 14. Gibs and gib screws.The bottom gib, shown in Figure 14, is mounted on the back inside edge of the main body castin
Comments to this Manuals